W-Series hard metal and rubber heavy duty slurry pumps are designed for the most difficult pumping applications. They handle highly abrasive, high density and erosive slurries.
Flue Gas Desulphurization (FGD)
Coal washing Metallurgy
Discharge: From 1” up to 18”
Head: Up to 240 ft.
Flow: Up to 22,000 gpm
Pressure: Up to 300 psi
Complete selection of metals and elastomers
Casing - Made of Ductile Iron with ribs to increase wear life against high pressure.
Wet Ends - Impellers, Liners, and Volutes are made of High-Chrome Alloy or Rubber, to resist wear, corrosion, erosion, and impact. The metal and rubber parts are interchangeable.
Impeller - Wide passage and recessed vanes help to lower internal velocity to extend wear life.
Wet parts - Designed for different working conditions including large particle or high head.
Most common type of seal for clean water using gland water to lubricate the packing through the lantern restrictor, preventing leakage from the casing. Simple structure, easy maintenance, and low cost, where expeller seal is not an option.
The expeller generates a reverse centrifugal force to prevent leakage. It can be used for single-stage pump or the first pump of multiple pumps in a series when the positive pressure at suction side is larger than that at discharge side by no more than 10%. No gland water is required. The slurry will not be diluted, therefore used where any dilution of slurry is not allowed.
Suitable for applications where no extra substance is allowed to mix with the fluid being pumped. Most commonly used with chemicals and the food industry.